Fuji Xerox ApeosPort-IV C3375 Administration Guide

3 Maintenance
78
Maintenance
3
6 Push the staple cartridge into the finisher until
it clicks into place.
7 Close the finisher front cover.
Note • If the front cover is not closed completely, a message appears and the machine will remain paused.
Replacing Staple Cartridge (for Finisher-C1 or Finisher-C1 with Booklet
Maker)
When the optional Finisher-C1 or optional Finisher-C1 with Booklet Maker is installed and
the staple cartridge needs to be replaced, a message appears on the touch screen. When this
message appears, load a new staple case into the staple cartridge.
This section explains how to replace the staple cartridge in the Finisher-C1 with Booklet
Maker, as an example. You can apply the same procedures to the Finisher-C1.
Important • The use of staple cartridges not recommended by Fuji Xerox may degrade quality and performance.
Use only staple cartridges recommended by Fuji Xerox.
Note • To order a staple cartridge, contact our Customer Support Center.
1 Make sure that the machine is not operating,
and open the finisher front cover.
2 Grasp the handle R1 of the staple cartridge
holder, and pull out the holder to the right,
towards you.

Fuji Xerox ApeosPort-IV C3375 Specifications

General

Print Resolution	1200 x 2400 dpi
Functions	Print, Copy, Scan, Fax
Duplex Printing	Yes
Memory (Standard)	2 GB
Copy Resolution	600 x 600 dpi
Scan Resolution	600 x 600 dpi
Fax Transmission Speed	33.6 kbps
Operating System Compatibility	Windows, Mac OS, Linux
Print Speed	35 ppm
Connectivity	Ethernet, USB
Paper Size	A3, A4, A5, B4, B5
Hard Drive	160 GB
Network Connectivity	Ethernet
Copy Speed (Color)	35 cpm
Copy Speed (Mono)	35 cpm