EasyManuals Logo

Fuji Xerox ApeosPort-IV C3375 Administration Guide

Fuji Xerox ApeosPort-IV C3375
731 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #359 background imageLoading...
Page #359 background image
Configuration of Job Flow Sheets
359
Scanner Environment Settings
9
4 Set an IP address and the other addresses.
Skip this step if an IP address is already set.
If DHCP or BOOTP is available in your environment, configure the method for obtaining the
addresses. If an IP address cannot be obtained automatically or manual configuration is
preferred, confirm the settings of an IP address, a subnet mask, and a gateway address.
For information on how to set an IP address, refer to "Protocol Settings" (P.201).
5 Select [Close] repeatedly until the [Tools] screen is displayed.
6 Select [Close].
Note • Rebooting the machine may be required depending on the settings. When a message displayed on
the screen, follow the message and reboot the machine.
7 Print a configuration report to confirm that the SOAP, SNMP, and Internet Services (HTTP)
ports are enabled and that TCP/IP is set up correctly.
For information on how to print a configuration report, refer to "Print Reports" (P.106).
Step 2 Configuring the SNMP Port
Configure the transport protocol for the SNMP port using CentreWare Internet Services.
1 Start CentreWare Internet Services.
For information on how to start CentreWare Internet Services, refer to "Starting CentreWare Internet Services" (P.312).
2 Configure the transport protocol for the SNMP port.
1) Click the [Properties] tab.
2) Click [ ] on the left of [Connectivity].
3) Click [Port Settings].
4) Select the [UDP] check box under [SNMP].
5) Click [Apply].
6) The right frame of the web browser changes to the machine reboot display.
7) Click [Reboot Machine]. The machine reboots and the settings are enabled.
Step 3 Configuration on the Computer
Create job flows using EasyOperator and Device Setup Tool to use for scanned documents.
Note • EasyOperator is included in the Driver CD Kit. Device Setup Tool is included in ApeosWare
Management Suite, which you can download from our web site. For information on creating job
flows, refer to the manual contained in the Driver CD Kit.

Table of Contents

Other manuals for Fuji Xerox ApeosPort-IV C3375

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fuji Xerox ApeosPort-IV C3375 and is the answer not in the manual?

Fuji Xerox ApeosPort-IV C3375 Specifications

General IconGeneral
Print Resolution1200 x 2400 dpi
FunctionsPrint, Copy, Scan, Fax
Duplex PrintingYes
Memory (Standard)2 GB
Copy Resolution600 x 600 dpi
Scan Resolution600 x 600 dpi
Fax Transmission Speed33.6 kbps
Operating System CompatibilityWindows, Mac OS, Linux
Print Speed35 ppm
ConnectivityEthernet, USB
Paper SizeA3, A4, A5, B4, B5
Hard Drive160 GB
Network ConnectivityEthernet
Copy Speed (Color)35 cpm
Copy Speed (Mono)35 cpm

Related product manuals