EasyManuals Logo

Fuji Xerox ApeosPort-IV C3375 Administration Guide

Fuji Xerox ApeosPort-IV C3375
731 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #321 background imageLoading...
Page #321 background image
Installation When Using USB Port
321
Printer Environment Settings
7
Installation When Using USB Port
This section describes how to install the machine using a USB interface.
The following shows the reference section for each procedure.
Step 1 Preparations .....................................................................................................................................................................321
Step 2 Configuration on the Machine.....................................................................................................................................321
Step 3 Configuration on the Computer ..................................................................................................................................322
CentreWare Internet Services Setting Items.........................................................................................................................322
Step 1 Preparations
The following items are required to connect the machine to a computer via a USB interface.
z
USB cable
z
The Driver CD Kit (provided with the machine)
z
The Adobe PostScript 3 Kit (optional) - this is required only when using a Macintosh
computer
Note • For Mac OS 9.2.2 English, and Mac OS X 10.3.9 - 10.4.11 English, Adobe PostScript3 Kit (optional) is
required. For Mac OS X 10.5/10.6/10.7 English, you can use EtherTalk without the Adobe PostScript 3
Kit (optional) if you install the print driver for Mac OS X contained in the CD-ROM provided with the
driver.
Step 2 Configuration on the Machine
The following describes the configuration procedures to use a USB interface on the
machine.
Note • To print binary data using a USB interface, set [Adobe Communication Protocol] to [RAW]. For more
information, refer to "USB" (P.196).
• You can configure the settings using CentreWare Internet Services. For items that can be configured
using CentreWare Internet Services, refer to "CentreWare Internet Services Setting Items" (P.322).
1 Display the [Tools] screen.
1) Press the <Log In/Out> button.
2) Enter the system administrator's user ID with the numeric keypad or the keyboard
displayed on the screen, and select [Enter].
When a passcode is required, select [Next] and enter the system administrator's
passcode, and select [Enter].
Note • The default user ID is "11111".
• The default passcode is "x-admin".
3) Select [Tools] on the [Services Home] screen.
2 Enable the USB port on the machine.
1) Select [Port Settings].
2) Select [Connectivity & Network Setup].
3) Select [USB], and then select [Change Settings].
4) Select [Port Status], and then select [Change Settings].
5) Select [Enabled], and then select [Save].

Table of Contents

Other manuals for Fuji Xerox ApeosPort-IV C3375

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fuji Xerox ApeosPort-IV C3375 and is the answer not in the manual?

Fuji Xerox ApeosPort-IV C3375 Specifications

General IconGeneral
Print Resolution1200 x 2400 dpi
FunctionsPrint, Copy, Scan, Fax
Duplex PrintingYes
Memory (Standard)2 GB
Copy Resolution600 x 600 dpi
Scan Resolution600 x 600 dpi
Fax Transmission Speed33.6 kbps
Operating System CompatibilityWindows, Mac OS, Linux
Print Speed35 ppm
ConnectivityEthernet, USB
Paper SizeA3, A4, A5, B4, B5
Hard Drive160 GB
Network ConnectivityEthernet
Copy Speed (Color)35 cpm
Copy Speed (Mono)35 cpm

Related product manuals