Print Service Settings
225
Tools
5
Receiving Buffer - IPP
îš„ No Spooling
Does not use spooling. While IPP printing is performed for one client, data cannot be
received over the same interface from another client.
Specify a value for the dedicated IPP receiving buffer memory capacity from 64 to 1024 KB
in 32 KB increments.
îš„ Spool to Hard Disk
Carries out spooling. The receiving buffer for spooling uses the hard disk.
Receiving Buffer - EtherTalk
Set the EtherTalk receiving buffer.
Specify a value from 1024 to 2048 KB in 32 KB increments.
Receiving Buffer - Port 9100
Set the Port 9100 receiving buffer.
Specify a value from 64 to 1024 KB in 32 KB increments.
Delete Form
You can delete registered ESC/P-K forms.
1 Select [Delete Form].
2 Select the print mode to delete forms.
3 Enter the form number with the numeric
keypad, and select [Confirm].
îš„ ESC/P
Deletes ESC/P-K emulation forms.
îš„ Form Number
When you select an item to delete, you can
enter the form number.
îš„ Form Name
After you enter the form number and select [Confirm], the form name matching the form
number entered appears.
4 Check the form name, and then select [Delete Data].
Other Settings
You can configure other settings related to the paper used in the printer.
Print Area
Set whether or not to expand the print area.
For more information about the printable area, refer to "Printable Area" (P.624).
For more information on the extended printable area, refer to "Extended Printable Area" (P.624).
To Next Page
Loading...
Need help?
General
