Fuji Xerox ApeosPort-IV C3375 Administration Guide

3 Maintenance
80
Maintenance
3
1 Make sure that the machine is not operating,
and open the finisher side cover.
2 Hold the tabs on both sides of the staple
cartridge and pull the cartridge out of the
finisher.
3 Hold the tabs on both sides of a new staple
cartridge, and insert it into the original position
until it clicks.
4 Repeat steps 2 and 3 to replace the other staple cartridge.
5 Close the finisher side cover.
Note • If the cover is not completely closed, a message will appear and the machine remain paused.
Replacing Staple Cartridge (for Finisher-C1 with Booklet Maker)
When the optional Finisher-C1 with Booklet Maker is installed and the staple cartridge needs
to be replaced, a message appears on the touch screen. When this message appears, load a
new staple case into the staple cartridge.
Important • The use of staple cartridges not recommended by Fuji Xerox may degrade quality and performance.
Use only staple cartridges recommended by Fuji Xerox.
Note • To order a staple cartridge, contact our Customer Support Center.
1 Make sure that the machine is not operating,
and open the finisher front cover.

Fuji Xerox ApeosPort-IV C3375 Specifications

General

Print Resolution	1200 x 2400 dpi
Functions	Print, Copy, Scan, Fax
Duplex Printing	Yes
Memory (Standard)	2 GB
Copy Resolution	600 x 600 dpi
Scan Resolution	600 x 600 dpi
Fax Transmission Speed	33.6 kbps
Operating System Compatibility	Windows, Mac OS, Linux
Print Speed	35 ppm
Connectivity	Ethernet, USB
Paper Size	A3, A4, A5, B4, B5
Hard Drive	160 GB
Network Connectivity	Ethernet
Copy Speed (Color)	35 cpm
Copy Speed (Mono)	35 cpm