Connectivity & Network Setup
197
Tools
5
îš„ PJL
PJL (Printer Job Language) is a job control language and a PJL command is data prepended
to the top of the print jobs. Usually select [Enabled].
îš„ Auto Eject Time
Configure the time that the data so far received by the machine will automatically be
printed since data is no longer sent to the printer.
You can enter a time between 5 and 1275 seconds in 5 seconds increments.
îš„ Adobe Communication Protocol
z
Standard
Select this when the output protocol of the print driver is in the ASCII format.
z
Binary
Select this when the output protocol of the print driver is in the BCP format.
z
TBCP
Select this when the output protocol of the print driver is in the TBCP format.
z
RAW
Select this when the output protocol of the print driver is in the ASCII or binary format.
The data is printed without being controlled by the Adobe communication protocol.
îš„ PostScript Wait Timeout
The machine automatically terminates a connection when the machine does not receive
data for a certain period of time. When data is being printed with [RAW] is selected for
[Adobe Communication Protocol], select [Disabled] if you want to use the time period set in
[Auto Eject Time] or select [Enabled] if you want to use the timeout period of PostScript.
LPD
îš„ Port Status
Select [Enabled] to use LPD.
îš„ Port Number
Enter a port number for LPD from 1 to 65535.
The default value is 515.
Important •Do not use the numbers assigned to the other ports.
îš„ Maximum Number of Sessions
Enter the maximum number of client sessions using LPD. You can enter a number from 1 to
10 in 1 session increments.
The default value is 5.
NetWare
îš„ Port Status
Select [Enabled] to use NetWare.
To Next Page
Loading...
Need help?
General
