5 Tools
218
Tools
5
îš„ LDAP - SSL/TLS Communication
Set whether or not to enable the SSL/TLS communications for authentication and searches.
If you enable the LDAP SSL/TLS communications, you must set [Primary Server - Port
Number] and [Secondary Server - Port Number] under [LDAP Server/Directory Service
Settings].
The port number for SSL/TLS communications of the LDAP directory server is normally set
to 636.
îš„ SMTP-SSL/TLS Communication
Configure the SSL/TLS communications.
z
Disabled
The machine does not communicate in SSL/TLS.
z
STARTTLS (If Available)
The machine verifies the certificate and communicates in SSL/TLS. If the verification fails,
the machine does not communicate in SSL/TLS.
z
STARTTLS
The machine verifies the certificate and communicates in SSL/TLS. If the verification fails,
the machine cannot perform communication.
z
SSL/TLS
The machine communicates in SSL/TLS.
Note • The Internet Fax Direct (P2P) feature does not support SMTP-SSL/TLS communication.
îš„ ThinPrint-SSL/TLS Communication
Select whether or not to enable the SSL/TLS communications.
îš„ Device Certificate - Client
Select a certificate for HTTP SSL/TLS communications.
îš„ Verify Remote Server Certificate
When the machine is operated as an SSL client, select whether or not to verify the certificate
of the remote server.
S/MIME Settings (ApeosPort Series Models Only)
Configure S/MIME settings.
îš„ Device Certificate - S/MIME
Select a certificate for S/MIME communications.
For more information on the certificate, refer to "Encryption and Digital Signature Settings" (P.385).
îš„ S/MIME Communication
Select whether or not to enable S/MIME communications.
îš„ Receive Untrusted E-mail
If you select [No], the machine does not receive the following e-mail:
z
E-mails other than e-mail sent by S/MIME when [S/MIME Communication] is set to
[Enabled].
z
E-mails that fail to attach a signature or verification.
z
E-mails that are attached with an expired certificate.
To Next Page
Loading...
Need help?
General
