Connectivity & Network Setup
167
Tools
5
Port 9100
Port Status
Select [Enabled] to use Port9100.
Select this option when the communication protocol is in RAW format for Windows Standard
TCP/IP port monitor.
Port Number
Enter a port number for Port9100 from 1 to 65535.
The default value is 9100.
Important • Do not use the numbers assigned to the other ports.
SNMP
Port Status
Select [Enabled] to use SNMP, when you use any web applications manufactured by Fuji
Xerox to control the machine on the network.
SIP
Port Status
Select [Enabled] to use SIP, when you use IP fax (SIP) transmission.
SIP Port Number
Enter a port number for IP fax (SIP).
The default value is 5060.
Important • Do not use any numbers assigned to other ports.
Note • IP fax (SIP) is not available for some models.
FTP Client
Port Status
Select [Enabled] when you use the Scan to PC service with FTP transmission.
Note • Select a communication mode to send data scanned via FTP from [Passive mode] and
[Active mode]. [Passive mode] is selected by factory default. You can change the setting
from CentreWare Internet Services.
Receive E-mail
Port Status
Select [Enabled] when you receive e-mails and Internet faxes.
Send E-mail
Port Status
Select [Enabled] when you send e-mails and Internet faxes.
E-mail Notification Service
Port Status
Select [Enabled] when you use the E-mail Notification Service. The E-mail Notification
Service notifies you of the machine status or the completion of a print job, and a direct fax job
by e-mail.
Note • [Consumables Status], [Parts Status], [Paper Tray Status], [Output Tray Status],
[Jam Status], [Interlock Status], and [Fault Notice] are notified as the machine
status.
• You can configure the E-mail Notification Service in CentreWare Internet Services. For more
information, refer to the help of CentreWare Internet Services.
To Next Page
Loading...