Fuji Xerox DocuCentre-IV 4070

5 Tools
168
Tools
5
UPnP Discovery
Port Status
Select [Enabled] to use UPnP.
Port Number
Enter a port number for UPnP communication from 1 to 65535.
The default value is 80.
Important • Do not use a number that is the same as a port number of another port. However, you can
use the same port number for a port that uses HTTP (IPP, Internet Services (HTTP), UPnP
Discovery, SOAP, WebDAV, and Web Services on Devices (WSD)).
WSD
WSD Print - Port Status
Select [Enabled] to use WSD Print.
Set this when you search a device on a network from Windows Vista and Windows 7.
WSD Scan - Port Status
Select [Enabled] to use WSD Scan.
Set this when you search a device on a network from Windows Vista and Windows 7.
Port Number
Enter a port number from 1 to 65535.
The default value is 80.
Important • Using the default port number may cause the conflict with other ports. Confirm the setting
that the port numbers assigned to the other ports are not used.
Note • WSD stands for Web Services on Devices.
Internet Services (HTTP)
Port Status
Select [Enabled] to use CentreWare Internet Services.
For more information about CentreWare Internet Services, refer to "CentreWare Internet Services
Settings" (P.269).
Port Number
Enter a port number for the Internet Services from 1 to 65535.
The default value is 80.
Important • Using the default port number may cause the conflict with other ports. Confirm the setting
that the port numbers assigned to the other ports are not used.
Note • You cannot select [Port Number], if HTTP port is disabled.
To configure [Port Number], enable port status and reboot the machine, and then configure
[Port Number].
SOAP
Port Status
Select [Enabled] when you use an application program such as EasyOperator.
Port Number
Enter a port number for SOAP from 1 to 65535.
The default value is 80.
Important • Using the default port number may cause the conflict with other ports. Confirm the setting
that the port numbers assigned to the other ports are not used.
WebDAV
Port Status
Select [Enabled] when you use an application program such as EasyOperator and Network
Scanner Utility 3 to access folders in the machine.