16 Appendix
624
Appendix
16
îš„Printed Time in Force Annotation
The time you specified to print a job, the time at which the print job is started inside the
machine, and the time at which the job is actually printed may not be coincident with
one another depending on the machine status and settings or the content of the print
job. The time printed in Force Annotation is the time at which the print job is started
inside the machine.
îš„Stored Programming
z
The following features and operations cannot be registered on a stored program.
- Registration and call of a stored program
- EP Diagnostic Request
- System Settings
- The [Media Print - Text] button on the [Services Home] screen
- The [Store to USB] button on the [Services Home] screen
- The [Network Scanning], [Job Flow Sheets], and [Web Applications] buttons on
the [Services Home] screen (ApeosPort series models only)
- A custom button to which the Network Scanning or Job Flow service is assigned
(ApeosPort series models only)
- Address Book for the Fax/Internet Fax, E-mail, and Scan to PC services
- Buttons that cannot be selected
- The [Language] button on the [Services Home] screen
- The [Screen Brightness] button on the [Services Home] screen
- The use of a scrolling bar when you select an item
- The [Browse] button of the Scan to PC service
- Address editing operation of the E-mail service ([Remove], [Edit], and [Close
Menu] on the pop-up menu)
- The <Energy Saver> button
z
After registering a program, you may not be able to retrieve the stored program
correctly if you execute the following operations:
- If a Watermark is registered on the program, and you change the default value of
the Watermark after registering the program
- If a passcode of a folder that is subject to operation by a stored program is
changed after the program is registered
- If the settings of the control panel are changed
- If the features registered on the custom buttons are changed
- If the setting is changed with [Tools] > [System Settings] > [Copy Service Settings]
> [Preset Buttons]
- If the program is selected from a list of a job flow or the Address Book
- If a button no longer functions as a result of a change of optional components such
as Finisher
- If the measurement unit such as mm or inch is changed
- If a file is selected from a file list with Job Status
îš„Operations during the Energy Saver mode
z
It takes about five seconds before you can operate the system settings under [Tools]
after the machine exits the Sleep mode.
z
The <Energy Saver> button still lights up when you perform the operations which do
not light up the touch screen such as printing command from a computer.
To Next Page
Loading...
Need help?
General
