3 Copy
174
Copy
3
of the sets you want to confirm during sorting and the pages you want to confirm during
stacking. Samples are output to the output tray at the top of stacker trays.
[Offset Stacking] screen
Allows you to select offset options.
The offset is a function for slightly offsetting and outputting each paper stack to allow you
to distinguish the separations. You can specify by set, job, specified number of pages, or
specified number of copies for a paper stack.
Note • When the offset option is set to [System Default], output is done to the destination set on the
machine. To change the machine setting, refer to "5 Tools">"Copy Service Settings"> "Copy
Defaults">"Output Destination" in the Administrator Guide.
Paper Size and Stapling Position
C3 Finisher (optional)/C3 Finisher with Booklet Maker (optional)
* : The staple orientation displayed on the touch screen differs from the actual staple orientation. Outputs are stapled in the
orientation shown in the above table.
Finisher D2-P with Booklet Maker (optional)
1 Staple
1 Top
Right
2 Staples 2 Top 2 Right
A4 , B5 ,
8 x 10" ,
8.5 x 11", 16K
A4, 8 x 10",
8.5 x 11",
8.5 x 13",
8.5 x 14"
A3, B4,
11 x 17", 8K
1 Staple
1 Top
Right
2 Staples 2 Top 2 Right
A4
B5 , 8 x 10" ,
8.5 x 11" ,
16K
To Next Page
Loading...
Need help?
General
