6 Problem Solving
102
Problem Solving
6
Staple Jams in the Staple Cartridge
The following describes remedy for staple jams in the staple cartridge.
1 Make sure that the machine has
stopped, and then open the front
cover on the light finisher.
2 Hold the R1 at the position shown
in the diagram.
3 Pull out the unit.
Note • After removing the staple
cartridge, check the inside of
the finisher for any remaining
staples.
4 Open the staple cartridge cover as
shown in the diagram and remove
the jammed staple.
5 Push the removed unit back to the
original position.
6 Close the Finisher right cover.
Note • A message will be displayed
and the machine will not
operate if the Staple Finisher's
right cover is even slightly
open.
If the staples cannot be removed
after carrying out the above procedures, contact our Customer Support Center.
Be careful in removing jammed
staples.
To Next Page
Loading...
Need help?
General
