5 Maintenance
64
Maintenance
5
Replacing the Staple Cartridge
When it is time to replace a staple cartridge, a message appears on the display. When
this message appears, replace the staple cartridge with a new one.
Important • The use of staple cartridges not recommended by Xerox may impair quality and
performance. Use only staple cartridges recommended by Xerox for the machine.
• The shape of the staple cartridge is different in Finisher D and Finisher D2. Use the staple
cartridge that suits each Finisher. The following describes the procedure of replacing the
staple cartridge for Finisher D2.
Note • To order a staple cartridge, contact our Customer Support Center.
1 Make sure that the machine has
stopped, and then open the right
cover on the light finisher.
2 Hold the R1 at the position shown
in the diagram.
3 Pull out the unit.
4 Hold the positions indicated by an
arrow to remove the staple
cartridge from the unit.
To Next Page
Loading...
Need help?
General
