5 Maintenance
68
Maintenance
5
Replacing the Staple Cartridge for Booklet
When a Finisher is installed and it is time to replace the staple cartridge for booklet, a
message appears on the display. When this message appears, replace the staple
cartridge with a new one.
Important • The use of staple cartridges not recommended by Xerox may impair quality and
performance. Use only staple cartridges recommended by Xerox for the machine.
Note • To order a staple cartridge, contact our Customer Support Center.
1 Make sure that the machine has
stopped, and then open the right
cover on the light finisher.
2 Pressing the lever to the right, pull
out the cartridge.
3 Holding the tabs of the booklet
staple cartridge, and then lift to
remove it.
4 Holding the tabs of a new booklet
staple cartridge, return the
cartridge to the original position
and gently push it until it clicks.
R2
R3
To Next Page
Loading...
Need help?
General
