3 Basic Operation
24
Basic Operation
3
Copying Procedure
This section describes the basic copy operations. The following shows the copy flow
and reference sections.
Step1 Loading Documents..........................................................................................................24
Step2 Selecting Features .............................................................................................................26
Step3 Entering the Quantity........................................................................................................27
Step4 Starting the Copy Job........................................................................................................28
Step5 Confirming the Copy Job in the Job Status ......................................................................28
Step1 Loading Documents
There are two methods for loading documents:
îš„Document feeder
z
Single sheet
z
Multiple sheets
îš„Document Glass
z
Single sheet
z
Bound documents, such as books
Document feeder
The document feeder supports single sheet and multiple sheet documents, with sizes
ranging from 140 × 210mm (A5, A5 , 5.5 × 8.5inches, 5.5 × 8.5inches ) to a
maximum of 297 × 432mm (A3, 11 × 17 inches).
The document feeder can auto-detect only documents of standard sizes. For
documents that of not of a standard size, input the size in the [Original Size] field.
The document feeder can accept the following number of sheets.
Important • Place folded or creased documents on the document glass because they may cause paper
jams.
Document type (weight)
Number of
sheets
Lightweight paper (38-49 g/m
2
) 250 sheets
Plain paper (50-80g/m
2
) 250 sheets
Heavyweight paper (81-128g/m
2
) 150 sheets
Heavyweight paper (129-200g/m
2
) 100 sheets
To Next Page
Loading...
