Copying Procedure
25
Basic Operation
3
1 Remove any paper clips and
staples before loading documents.
2 Shift the document guide gently to
touch the document edges.
3 Adjust the movable document
guides to just touch the edge of the
document stack.
Note • The <Confirmation> indicator
lights when the document is
loaded correctly.
When placing the document in the
DADF, you can set timing for lifting
up the document feeder tray.
Document Glass
On the document glass, you can place a single sheet, or a book or other similar
document, up to 297 × 432 mm (A3, 11 × 17 inches).
The document feeder can auto-detect only documents of standard sizes. For
documents that of not of a standard size, input the size in the [Original Size] field.
1 Open the document cover.
2 Place the document face down,
and align it against the inside left
corner of the document glass.
3 Close the document cover.
Note • When a standard size
document is loaded on the
document glass, the size of
the document is displayed in
the message area.
Do not apply excessive force to hold thick document on the platen glass. It may break
the glass and cause injuries.
To Next Page
Loading...
Need help?
General
