4 Paper and Other Media
52
Paper and Other Media
4
Loading Paper in Trays 6 to 7
Following describes the procedure for loading paper in the optional trays 6 to 7.
1 Pull out the tray towards you until it
stops.
Important • While the machine processes
a job, do not pull the tray out
that the job uses.
2 Load and align the edge of the
paper against the right edge of the
tray with the side to be copied or
printed on facing up.
Important • Do not load paper exceeding
the maximum fill line. Doing so
might cause paper jams or
machine trouble.
3 Push the tray in gently until it comes to a stop.
Loading Paper in Interposer
Following describes the procedure for loading paper in interposer.
Interposer is meant for loading paper (blank, copied paper, etc.) to be used as
separators and covers, so it cannot copy.
Note • When adding paper to interposer, remove any paper remaining in the tray, add it to the stack
of paper to be added, then load all of the paper into the interposer at once.
1 Hold the center of the paper guides
and slide them to the desired paper
size.
2 Load the paper, aligning to the front
side of the tray.
When pulling out the paper tray,
do it slowly. If pulled out with too
much force, the tray can hit and
injure your knees.
MAX
To Next Page
Loading...
Need help?
General
