To Next Page

To Previous Page

6 Problem Solving

Problem Solving

4 Close the Finisher right cover.

Note • A message will be displayed and the machine will not operate if the Staple Finisher's right

cover is even slightly open.

Paper jams at knob 2c, levers 2e/2f and tri-fold output tray 2d.

1 Make sure that the machine has

stopped, and then open the right

cover on the light finisher.

2 Pull out the tri-fold output tray [2d],

swing lever [2e], and remove the

jammed paper.

Note • If paper is torn, check for any

torn pieces of paper inside the

machine.

3 If you cannot remove the paper in

Step 2, return lever [2e] to the

original position. Swing lever [2e],

turn knob [2c] to the right, then

remove the jammed paper.

Note • If paper is torn, check for any

torn pieces of paper inside the

machine.

4 Swing back the opened lever ([2f]

or [2e]), and push back the tri-fold

output tray [2d].

5 Close the Finisher right cover.

Note • A message will be displayed and the machine will not operate if the Staple Finisher's right

cover is even slightly open.

Fuji Xerox Document Centre 1100 Quick Reference Guide

Other manuals for Fuji Xerox Document Centre 1100