122 Printing Basics
5 Load the print media into the tray with the recommended print side facing up.
NOTE:
• Do not exceed the maximum fill line in the tray. Overfilling the tray may cause paper jams.
6 Align the width guides and length guide against the edges of the print media.
7 After confirming that the guides are securely adjusted, insert the tray into the printer.
IMPORTANT:
• Do not use excessive force on the tray. Doing so could damage the tray or inside of the printer.
NOTE:
• If the front side of the tray is extended, the tray protrudes when it is inserted into the printer.
8 On the operator panel, select the appropriate paper size, and then press the button.
9 Select the appropriate paper type, and then press the button.
Loading Letterhead in the Standard 250 Sheet Tray and the
Optional 250 Sheet Feeder
When you use the standard 250 sheet tray and the optional 250 sheet feeder, letterhead and hole punched paper
must be inserted top edge first with the print side facing up.
To Next Page
Loading...
Need help?
General
