Fuji Xerox DocuPrint P355 d

158 Using the Operator Panel Menus
• PS Job Time-out
Purpose:
To specify the runtime of one PostScript job. The change becomes effective after the printer is turned off and then on
again.
Values:
• PaperSelect Mode
Purpose:
To set the way to select the paper tray for PostScript mode. The change becomes effective after the printer is turned
off and then on again.
Values:
Network Setup (DocuPrint P355 d Only)
Use the Network Setup menu to change the printer settings affecting jobs sent to the printer through the network.
NOTE:
• Values marked by an asterisk (*) are the factory default menu settings.
• Ethernet
NOTE:
• Ethernet feature is available only when the printer is connected using the wired network.
Purpose:
To specify the communication speed and the duplex settings of Ethernet. The change becomes effective after the
printer is turned off and then on again.
Values:
Off* Job time-out does not occur.
On 1min A PostScript error occurs if processing is not completed after the specified
time.
1-900min
Auto* The tray is selected as the same setting as in the PCL mode.
Select FromTray The tray is selected in a method compatible with regular PostScript printers.
Auto
*
Detects the Ethernet settings automatically.
10BASE-T Half Uses 10BASE-T Half-duplex.
10BASE-T Full Uses 10BASE-T Full-duplex.
100BASE-TX Half Uses 100BASE-TX Half-duplex.
100BASE-TX Full Uses 100BASE-TX Full-duplex.
1000BASE-T Full Uses 1000BASE-T Full-duplex.