Using the Operator Panel Menus 167
• Audio Tones
Purpose:
To configure settings for tones emitted by the printer during operation or when a warning message appears.
Values:
• mm / inch
Purpose:
To specify the default measurement unit displayed after the numeric value on the operator panel.
Values:
NOTE:
• The default for mm/inch varies depending on other settings, such as Region and Document Size.
• DefaultPaperSize
Purpose:
To specify the default paper size.
Values:
NOTE:
• The default for DefaultPaperSize varies depending on region-specific factory default.
Control Panel Off
*
Does not emit a tone when the operator panel input is correct.
On Emits a tone when the operator panel input is correct.
Invalid Key Off
*
Does not emit a tone when the operator panel input is incorrect.
On Emits a tone when the operator panel input is incorrect.
Machine Ready Off Does not emit a tone when the printer is ready to process a job.
On
*
Emits a tone when the printer is ready to process a job.
Job Completed Off Does not emit a tone when a job is complete.
On
*
Emits a tone when a job is complete.
Fault Tone Off Does not emit a tone when a job ends abnormally.
On
*
Emits a tone when a job ends abnormally.
Alert Tone Off Does not emit a tone when a problem occurs.
On
*
Emits a tone when a problem occurs.
Out of Paper Off Does not emit a tone when the printer runs out of paper.
On
*
Emits a tone when the printer runs out of paper.
Low Toner Alert Off Does not emit a tone when a toner is low.
On
*
Emits a tone when a toner is low.
AutoClear Alert Off* Does not emit a tone 5 seconds before the printer performs auto
clear.
On Emits a tone 5 seconds before the printer performs auto clear.
All Tones Off Disables all the alert tones.
On Sets the volume of all the alert tones at once.
Millimeters(mm)
*
Selects millimeter as the default measurement unit.
Inches(") Selects inch as the default measurement unit.
A4 - 210x297
Letter - 8.5x11
To Next Page
Loading...
