220 Troubleshooting
Protrudent/Bumpy Paper
Images Are Skewed
Problem Action
Printed surface got
protrudent/bumpy.
Clean up the fusing unit.
1 Load one sheet of paper in the bypass tray, and then print a solid image all over
paper.
2 Load the printed sheet with the side to be printed on facing down, and then print a
blank sheet of paper.
If the problem persists, contact the Fuji Xerox local representative office or an
authorised dealer.
Problem Action
The printed result are skewed. Adjust the paper guides properly.
If the problem persists, install the transfer unit according to an appropriate procedure.
Install the transfer unit according to an appropriate procedure.
See also:
• "Installing a Transfer Unit" on page 243
If the problem persists, contact the Fuji Xerox local representative office or an
authorised dealer.
To Next Page
Loading...
