Error Code
241
Problem Solving
11
"041-001" - "044-999"
029-716 [Cause]
Ethernet 1 error. A timeout error occurred when the printer obtains
the URL of a proxy auto-config (PAC) file.
[Remedy]
Check and correct the following:
LAN cable connection
Default gateway configuration
Subnet mask configuration
If the failure persists, the network or the DHCP server may have a
problem. Consult your network administrator.
If the error still is not resolved, contact our Customer Support
Center.
029-717 [Cause]
Ethernet 1 error. An error occurred when the printer obtains a
proxy auto-config (PAC) file. The file was not found. The PAC file
location setting on the DHCP server may have a problem.
[Remedy]
Consult your network administrator.
If the error still is not resolved, contact our Customer Support
Center.
Error
Code
Cause/Remedy
041-310 [Cause]
An error occurred.
[Remedy]
Switch off the machine power, make sure that the touch screen is
blank, and then switch on the machine power. If the same
message is displayed again, contact our Customer Support Center.
041-340
041-341
[Cause]
An error occurred.
[Remedy]
Switch off the machine power, make sure that the touch screen is
blank, and then switch on the machine power. If the same
message is displayed again, contact our Customer Support Center.
041-363 [Cause]
An error occurred in the machine.
[Remedy]
Switch off the machine power, make sure that the touch screen is
blank, and then switch on the machine power. If the same
message is displayed again, contact our Customer Support Center.
041-388 [Cause]
An error occurred in the machine.
[Remedy]
Switch off the machine power, make sure that the touch screen is
blank, and then switch on the machine power. If the same
message is displayed again, contact our Customer Support Center.
042-313 [Cause]
An error occurred in the machine.
[Remedy]
Switch off the machine power, make sure that the touch screen is
blank, and then switch on the machine power. If the error still is
not resolved, contact our Customer Support Center.
042-325 [Cause]
An error occurred in the machine.
[Remedy]
Switch off the machine power, make sure that the touch screen is
blank, and then switch on the machine power. If the error still is
not resolved, contact our Customer Support Center.
Error
Code
Cause/Remedy