Loading Paper
51
Paper and Other Media
4
4 To load the envelopes, select an option:
To prevent jams, ensure that the leading edge of the envelopes are flat or have only a slight upward curl, less
than 5 mm, before loading into the tray. If the edge is curled or swollen, fold it over to decurl. The length of
the curl must be within 8-10 mm. Downward curl at the leading edge of envelopes is not acceptable and can
cause a jam or misfeed.
Load envelopes up to 16.5 mm in height. This is approximately 10-20 envelopes, depending on brand, size,
and texture.
If you do not load envelopes in the Bypass Tray right after you have removed the envelopes from the
packaging, the envelopes can bulge. To avoid jams, flatten the envelopes before loading them into the tray.
For Number 10 envelopes, load the envelopes with the short edge going into the printer,
flaps down, and flaps to the right.
For Monarch or DL envelopes, perform one of the following steps. If the envelopes
wrinkle, try another option.
- Load envelopes with the short edge going into the printer, flaps down, and flaps to the
right.
To Next Page
Loading...
Need help?
General
