Troubleshooting and tips
A26391-LJ1-Z120-1-7619 49
The mouse does not work
If the connected mouse does not work, the following can cause it:
Mouse driver is not loaded
Ê Check whether the correct mouse driver is properly installed and is present before the
application programme is started.
Detailed information can be found in the User Guides for the mouse or application programme.
Mouse is not connected
Ê Switch off the notebook.
Ê Check whether the mouse cable is correctly connected to the notebook.
If you use an adapter or extension lead with the mouse cable, check the connections.
Ê Switch the notebook on.
The floppy disk cannot be written
Ê Check whether the disk is OK and is not write-protected.
The printer does not print
Ê Make sure that the printer is switched on and is on-line (see the manuals supplied with the
printer).
Ê Check that the cable connecting the notebook and the printer is connected properly.
Ê Check that the correct printer driver is installed.
Ê Check in the BIOS Setup whether the Advanced - I/O Device Configuration field is set correctly for
the port you are using. The respective entry in the fields of Serial Port or Parallel Port must
match the setting in the application programme under Windows ME.
Acoustic warnings
A beep sounds every few seconds
The battery is almost flat.
Ê Charge the battery.
To Next Page
Loading...
Need help?
General
