A26391-LJ1-Z120-1-7619 53
Memory extension
!
The notebook must be switched off when installing/removing the memory modules and
may not be in the Suspend mode.
So that the current data can be saved in the Save to Disk suspend mode, sufficient
memory space must be available on the hard disk (at least the size of the main
memory +16 Mbytes).
Install only memory expansions that satisfy the requirements and rules governing safety,
RFI and electromagnetic compatibility and relating to telecommunications terminal
equipment (see the chapter "Important notes").
Use only memory expansions which have been released for your notebook (64 and
128 Mbyte modules, SD RAM, JEDEC 144 pin SO DIMM, 3.3 V).
Never use force when installing or removing memory modules.
Make sure that foreign objects do not fall into the memory module compartment.
The main memory of your notebook can be expanded to 256 Mbyte using a second 128 Mbyte
memory module. The notebook will not start without memory modules, as no fixed main memory is
installed.
Removing and installing memory extension
!
Please note the information provided in the "Notes on installing and removing boards and
modules " section in the chapter "Important notes ".
Ê Switch off the notebook.
Ê Remove the battery (see "Removing the battery").
Ê Unplug the power adapter from the mains outlet.
Ê Close the LCD screen so that it locks into place.
Ê Disconnect all cables connected to the notebook.
Ê Place the notebook upside down on a flat surface.
To Next Page
Loading...
Need help?
General
