Troubleshooting and tips
A26391-LJ1-Z120-1-7619 51
Failure Fixed Disk n
The settings of the hard disk drive are incorrect.
Ê Start the BIOS Setup (IDE Adapter 0 Master submenu) and select the correct settings.
Fixed Disk address conflict Diskette Drive address conflict
There is an I/O address conflict.
Ê Start the BIOS Setup and check the corresponding settings.
Incorrect Drive A type - run SETUP
Ê Start the BIOS Setup and make sure that the parametre for floppy disk drive A has been set to
the format 1.44 Mbyte, 3 1/2 inch.
Keyboard controller error
Ê Switch off the notebook with the Suspend/Resume button.
Ê Wait3-5seconds and switch on the notebook again.
If this error message appears again, please contact your point of sale or our Hotline/Help Desk.
Keyboard error
If you use an external keyboard:
Ê Check the connection and reboot the notebook.
If this error message appears again, please contact your point of sale or our Hotline/Help Desk.
nn Stuck key
Ê Make sure that no key is pressed.
If this error message appears again, please contact your point of sale or our Hotline/Help Desk.
Operating system not found
Ê Check in the BIOS Setup whether your hard disk has been set correctly.
Ê Make sure that the operating system is installed on the corresponding drive.
Not enough Save-to-Disk partition or file exists on Fixed Disk - Save-to-Disk feature is
disabled.
The Save-to-Disk mode is not available to you, as no memory space has been assigned to this
mode.
Ê Use the PHDISK service programme to assign the memory space required for this mode.
To Next Page
Loading...
Need help?
General
