System expansions Installing and removing a board
38 A26361-K520-Z300-3-7619
Installing and removing a board
!
Observe the notes on installing and removing boards in the chapter "Important notes".
Old ISA boards, which require a -5 V power supply, are not supported.
The number, position and arrangement of the board slots on the system board can be found in the
Technical Manual for the system board. Boards may already be installed when the device is
shipped.
Installing a board
Ê Open the casing (see "Opening the casing").
3
1
2
Ê Push the edges of the clip together (1) and remove it (2).
Ê Remove the cover plate from the slot (3).
!
Do not dispose of the cover plate. For cooling, protection against fire and in order to
comply with EMC regulations, you must refit the cover plate if you remove the board.
Ê Take the new board out of its packaging.
Ê Make the required settings for the board.
To Next Page
