03-01
3-1. FUNCTION SETTING
Follow the instructions in the Local Setup Procedure, which is supplied with the remote control,
in accordance with the installed condition.
After the power is turned on, perform the Function Setting on the remote control.
The settings may be selected between the following two: Function Number or Setting Value.
Settings will not be changed if invalid numbers or setting values are selected.
3-1-1 INDOOR UNIT
1-2. Setting the Ceiling Height (For AB / AU type)
Setting Description Function Number Setting Value
Standard
3.2 m (2.7 m to 4.0 m)
High ceiling
5.0 m (4.0 m to 5.0 m)
20
00
01
The ceiling height values are fore the 4-way outlet.
Do not change this setting in the 3-way or 2-way outlet mode.
Select the setting values in the table below according to the height of the ceiling.
(The unit is factory set to "00".)
( Factory setting)
Setting Description Function Number Setting Value
Standard
2,500 hours
Long interval
4,400 hours
Short interval
1,250 hours
No indication
11
00
01
02
03
1-1. Setting the Filter Sign (For AB / AU type)
The indoor unit has a sign to inform the user that it is time to clean the filter.
Select the time setting for the filter sign display interval in the table below according to
the amount of dust or debris in the room.
(The unit is factory set to "00")
If you do not wish the filter sign to be displayed, select the setting value for "No indication".
( Factory setting)
For AU type
02
Low ceiling
2.5 m (2.5 m to 2.7 m)
Setting Description Function Number Setting Value
Standard
2.3 m to 3.0 m
20
00
01
( Factory setting)
For AB type
High ceiling
3.0 m or more
To Next Page
Loading...
Need help?
General
