Fujitsu AIRSTAGE UTY-DCGGZ2 - 1-5. Initial Setting

En-12
1-5. InitialSetting
After Central remote controller installation work is complete, perform initial setting by the following procedure before
starting to use the system.
Ifthepoweristurnedoffwithin5minutesofnishingthesettings,thesettingsmaynotbesaved.
Note
Initialsettingstart
Initialsettingend
Operation start
(Refer to Chap. 2.)
Turnonthepower
(Breaker ON)
Onlywhenthepoweristurnedonforthersttimeorimmediatelyafter
initialization is set, the following wizard are displayed in wizard format.
Perform the settings.
(1) LanguageSetting→Refer to 3-4-1(4).
(2) PanelCalibration→Refer to 3-2-2(4).
(3) CentralControllerAddressSetting→Refer to 3-4-2(4).
(4) IndoorUnitRegistration→3-4-3-1AddressNumberRegistration.
(5) DateSetting→Refer to 3-2-4-1, 3-2-4-2.
Monitoring screen is displayed. Perform the settings as necessary.→Refer to
Chap. 3.
Air conditioning starts on the Monitoring screen.