Function setting procedure
1. Connect the power supply of the outdoor unit.
2. To enter the function setting mode, while holding down the POWERFUL and SET TEMP.
buttons, press the RESET button.
POWERFUL
SET TEMP.
(
)
RESET
Function setting
mode display
3. Select the function number by pressing the or the buttons. Each time the 10°C HEAT
button is pressed, it switches between the right digit and the left digit.
4. Proceed to the setting number by pressing the POWERFUL button. (To return to the function
number selection, press the POWERFUL button again.)
5.
Select the function number by pressing the or the button. Each time the 10°C HEAT but-
ton is pressed, it switches between the right digit and the left digit.
- 223 -
15-2. Indoor unit (setting by wireless remote controller) 15. Function settings
2-UNIT
MULTI-SPLIT TYPE
2-UNIT
MULTI-SPLIT TYPE
To Next Page
Loading...
Need help?
General
