Getting started
Setting u p the device
WorkstationErgonomicDevice
When installing your device, please read the recommendations and safety
notes in the "Safety/regulations" manual.
We recommend that you place your device on a surface which is not slippery. In
view of the man y different finishes and varnishes used on furniture, it is possible
that the rubber feet w ill mark the surface they stand on.
Depending on the location of your device, bothersome vibrations and no ises may
occur. To pre vent this, a distance of at least 10 mm / 0.39" should be maintained
from other devices on casing sides without ventilation surfaces.
In order to avoid overheating, do not cover the ventilation areas
of the monitor or the device.
A minimu m distance of 200 mm / 7.87" from the device must be
observed for ventilation areas.
Do not stack several devices on top of each other.
Do not expose t he device to extreme ambient conditions (see "
Technical
specification", Page 43 , section "Ambient conditions"). P rotect the
device against dust, humidity and heat.
Operating positi
on
Use the device on
ly in the vertical operating position.
Connecting the device to the mains supply
Mainsadapter
2
1
► Conn
ect the power c able to the device (1).
► Plug the power plug into a grounded mains outlet (2).
12 Fujitsu
To Next Page
Loading...
