Fujitsu ESPRIMO P556 - Installing and removing an accessible 31;2 inch drive

System expansions
Installing and removing an accessible 3
1
/
2
inch drive
Installing an accessible dri
ve
► O pen the casing (see "Opening the casing", Page 30).
Diskettedri ve,Diske ttedrive,
► If there is an accessible 5
1
/
4
" drive, remove the drive (see "Removing
an accessible drive", Page
32).
► Remove the front panel from the c asing.
► F rom the inside, press th
e plastic drive cover out of the front panel.
1
► Break out the
pre-stamped me tal cover on the drive bay opening with a screwdriver (1).
► Secure the front panel on the casing again.
2
2
1
► Slide the drive into the casing (1). Make sure that the screw holes are aligned.
► F a sten the drive into place with the screws (2).
► Plug the data and the power supply connectors into the drive. Make sure the polarity is correct.
34 Fujitsu