System expansio ns
Do not throw away the slot cover. For cooling, protection against fireandinorderto
comply with EMC regulations, y ou must refit the slot cover if you remove the board.
2
1
► Push the board in
to the s lot (1).
► Tighten the screw on the slot c over (2).
► Secure the cove
r plate on the casing again.
► If necessary, connect the cables to the board.
► Close the casi
ng (see "
Closing the casing" , Page 31).
If you have i n
stalled or removed a board, please check the relevant PCI
slot setting
sintheBIOS Setup. If necessary, change the s ettin gs. Further
informatio
n is provided in the PCI board documentation.
Board remo
ving
► Open the casing (see "Opening the casing", Page 30).
Board,
► Remove th
e cover plate (see "
Board installing", Page 38).
► Disconnect the cables connected to the board.
Fujitsu 39
To Next Page
Loading...
