System expansions
Installing and removing the har
ddiskdrive
Harddiskdrive,Harddiskdrive,Harddiskdrive,
Removing a hard disk drive
► O pen the casing (see "Opening the casing", Page 30).
Harddiskdr ive,
► R emove all connected cables (data cable, power supply) from the drive.
1
1
1
1
2
► Undo the screws (1) and gently press against the hard disk drive from underneath.
► Pull the drive backwards a short way out of the bay in the dire ction of the arrow (2 ).
The drive now protrudes slightly out of the bay.
► Pull the drive completely out of its ba y. Make sure that you are not touching other components.
► If necessary, make the req uired settings on the rema ining hard d isk drive.
► Close the casing (see "
Closing the casing" , Page 31).
It may be necessary to modify the entry for the remaining drives in the BIOS Setup.
You will need a S ATA cable to install a second hard disk on the listed device variants.
36 Fujitsu
To Next Page
Loading...
