Fujitsu fi-4860C2

7-26
7.3 Setup Mode Details
3) In case of (2) or (3), by pressing (Enter button), LCD display changes to
<Screen5-1>.
<Screen5-1>
4) At <Screen5-1>, by pressing (Left arrow button) or (Right arrow button),
the document length can be specified.
By pressing (Right arrow button), selection moves from (1) to (3).
By pressing (Left arrow button), selection moves from (3) to (1).
5) Press (Enter button) to confirm the setting.
Press (Exit button), and the LCD display goes back to [Ready] screen.
(1) [10] is blinking: The document length difference below 10mm is not
detected as an error.
(2) [15] is blinking: The document length difference below 15mm is not
detected as an error.
(3) [20] is blinking: The document length difference below 20mm is not
detected as an error.
05
eL
!
n
tg
0
1
5
1/1
0
2/
-
h
mm
=