Fujitsu fi-4860C2 - Page 297

●AP-3
- Punched holes are not allowed within 35mm (1.4 inch) of the vertical center line
of the document.
- The deviation in the amount of the light transmitted through background areas
must not be less than 10%.
 Detection by Document Overlapping and Length
Sheets of the same thickness and length shall be set in the ADF at a time.
- Paper weight: 52 g/m
2
- 127 g/m
2
or 14 lbs to 34 lbs
- Document length deviation: 1% or less
- Printed area: 12% or less
- No black printed areas are allowed at the center area (26 x 10mm or 1 x 0.4
inch) at the leading edge of the document.
- Punched holes are not allowed within 35mm (1.4 inch) of the vertical center line
of the document.
- The deviation in the amount of the light transmitted through background areas
must not be less than 10%.
 Detection by Document Thickness and Length
Sheets of the same thickness and length shall be set in the ADF at a time.
- Paper weight: 52 g/m
2
- 127 g/m
2
or 14 lbs to 34 lbs
- Document length deviation: 1% or less
- Printed area: 12% or less
- No black printed areas are allowed at the center area (26 x 10mm or 1 x 0.4
inch) at the leading edge of the document.
- Punched holes are not allowed within 35mm (1.4 inch) of the vertical center line
of the document.
- The deviation in the amount of the light transmitted through background areas
must not be less than 10%.
 Detection by Document Overlapping, Thickness and Length
Sheets of the same thickness and length shall be set in the ADF at a time.
- Paper weight: 52 g/m
2
- 127 g/m
2
or 14 lbs to 34 lbs
- Document length deviation: 1% or less
- Printed area: 12% or less
- No black printed areas are allowed at the center area (26 x 10mm or 1 x 0.4
inch) at the leading edge of the document.
- Punched holes are not allowed within 35mm (1.4 inch) of the vertical center line
of the document.