1-8
1.3 Basic Operations of the Operator Panel
(2) In test mode ([Single feed] or [Multi-feed], the Hopper height changes as
follows by pressing (Next button):
1. When the Hopper is at the bottom position, it moves up to 250 sheet position.
2. When the Hopper is at 250 sheet position, it moves down to the bottom
position.
3. When the Hopper is at the highest position, it moves back to where it was when
the scan operation started.
ATTENTION
Pressing (Previous button) does not change the position.
HINT
The Hopper is positioned at the bottom when the power is turned on.
To Next Page
Loading...
