Fujitsu fi-4860C2

3-9
3.3 Cleaning the Rollers
3
DAILY CARE
6. When [Hopper Empty] is displayed, press (Stop button).
7. Place the same cleaning sheet on the hopper table with adhesive side up
by aligning the right side with the hopper guide. Press (Start button),
then the cleaning sheet is fed.
8. When "Hopper Empty" is displayed, press (Stop button).
9. Remove the protective paper from a new cleaning sheet and place it with
the adhesive side face down on the hopper table, aligning the left side
with the hopper guide. Press (Start button), then the cleaning sheet
is fed.
Repeat steps 6 through 8. When the cleaning is completed turn off the power.