AP-4
Appendix2 DAILY CARE
■ Cleaning Materials
*1) For details about cleaning materials, contact the
FUJITSU scanner dealer where you purchased the
scanner.
■ Cleaning Method
The ADF must be cleaned with a lint-free cloth moist-
ened with the Cleaner F1.
■ Parts to Clean and When
For details on the cleaning the ADF, refer to "3.3 Clean-
ing the ADF" in fi-5120C/fi-5220C Operator’s Guide on
the Setup CD-ROM".
• The glass surface inside the
ADF becomes hot during the
operation.
Before you clean inside the
scanner, turn off its power and
unplug the AC adapter from
the outlet. Wait for at least
15 minutes.
Do not turn off the scanner
when you clean the Feed roll-
ers.
• When you perform cleaning,
make sure that the inside of
the scanner is free of any for-
eign object, and be careful not
to get your hand or the cloth
caught on the pick spring
(metal part) as a deformed
pick spring (metal part) may
cause injury.
Cleaning
Materials
Parts
Number
Remarks
Cleaner F1 PA03950-
0352
1 bottle
Moisten the cloth with
this fluid and wipe the
scanner clean. (*1)
Cleaning Wipe PA03950-
0419
24 sheets/pack
Pre-moistened with
Cleaner F1, Cleaning
Wipes are used instead
of moistened cloths.
(*1)
Lint-free dry
cloth
Commercially available one
It may take long before the cleaner
vaporizes if a large quantity is used.
When cleaning the scanner parts,
dampen a cloth with modest quantities of
the cleaner. In addition, wipe off the
cleaner completely with a soft lint-free
cloth to leave no residue on the surface
of the cleaned parts.
Part to clean Standard Cleaning Cycle
Pad ASSY Clean these parts after every
1,000 scans.
Pick roller
Feed rollers
Plastic rollers
Glass
The scanner must be cleaned frequently
if you scan any of the following type of
paper sheets:
• Documents of coated paper
• Documents that are almost completely
covered with printed text or graphics
• Chemically treated documents such as
carbonless paper
• Documents containing a large amount
of calcium carbonate
• Handwritten documents
To Next Page
Loading...
Need help?
General
Weight and Dimensions
