EasyManuals Logo

Fujitsu fi-5220C Getting Started Guide

Fujitsu fi-5220C
29 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
ii
INTRODUCTION
Thank you for purchasing the fi-5120C/fi-5220C
Duplex Color Scanner product.
This document describes how to handle fi-5120C/fi-
5220C Duplex Color and basic operation methods.
Before you start using fi-5120C/fi-5220C Duplex Color
be sure to thoroughly read this manual to ensure correct
use.
The "Operator’s Guide" is stored on the Setup Disk.
The guide provides useful and detailed information on
Operations when you would like to using advanced fea-
tures, daily maintenance of the scanner, replacement of
consumables.Please also read the Operator’s Guide for
your reference.
Regulatory Information
FCC Declaration
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates,
uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the
instruction manual, may cause harmful
interference to radio communications. However,
there is no guarantee that interference will not
occur in a particular installation. If this equipment
does cause harmful interference to radio or
television reception, which can be determined by
turning the equipment off and on, the user is
encouraged to try to correct the interference by
one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment
and receiver.
Connect the equipment into an outlet on a circuit
different from that to which the receiver is
located.
Consult your dealer or an experienced radio/TV
technician.
FCC warning: Changes or modifications not
expressly approved by the party responsible for
compliance could void the users authority to
operate the equipment.
Canadian DOC Regulations
This digital apparatus does not exceed the Class B
limit for radio noise emissions from digital
apparatus set out in the Radio interference
Regulations of the Canadian Department of
Communications.
This Class B digital apparatus complies with
Canadian ICES-003.
Le présent appareil numérique n'émet pas de
parasites radioélectriques dépassant les limites
applicables aux appareils numériques de la classe
B et prescrites dans le Règlement sur le brouillage
radioélectrique dictées par le Ministère des
Communications du Canada.
Cet appareil numérique de la classe B est
conforme à la norme NMB-003 du Canada.
Bescheimigung des Herstellers /
Importeurs
Für den fi-5120C/fi-5220C wird folgendes
bescheinigt:
In Übereinsstimmung mit den Bestimmungen
der EN45014(CE) funkentstört
Maschinenlärminformationsverordnung 3.
GPSGV: Der höchste Schalldruckpegel beträgt
70 dB (A) oder weniger, gemäß EN ISO 7779.
International ENERGY STAR
®
Program
As an ENERGY
STAR
®
Partner, PFU
LIMITED has
determined that this
product meets the
ENERGY STAR
®
guidelines for energy
efficiency.
The International
ENERGY STAR
®
Office Equipment Program is an international
program that promotes energy saving through the
penetration of energy efficient computers and
other office equipment. The program backs the
development and dissemination of products with
functions that effectively reduce energy
consumption. It is an open system in which
business proprietors can participate voluntarily.
The targeted products are office equipment such
as computers, monitors, printers, facsimiles,
copiers, scanners, and multifunction devices.
Their standards and logos are uniform among
participating nations.
ATTENTION
The use of a shielded interface cable is
required to comply with the Class B limits
of Part 15 of FCC rules.
The length of the AC cable must be 2
meters (6.6 feet) or less.

Other manuals for Fujitsu fi-5220C

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fujitsu fi-5220C and is the answer not in the manual?

Fujitsu fi-5220C Specifications

General IconGeneral
Film scanningNo
Color scanningYes
Input color depth24 bit
Maximum scan size210 x 297 mm
Optical scanning resolution600 x 600 DPI
Flatbed scan speed (b/w, A4)2 sec/page
Scanner typeFlatbed & ADF scanner
Sensor typeCCD
ISO A-series sizes (A0...A9)A4, A5
Maximum ISO A-series paper sizeA4
Auto document feeder (ADF) input capacity50 sheets
USB version2.0
Standard interfacesSCSI, USB 2.0
Bundled software-FJ TWAIN driver. -Scandall. -Adobe Acrobat. -ISIS Driver. -QuickScan (demo). -Soft IPC (demo). -VRS 4.1 Basic.
Dimensions (WxDxH)302 x 569 x 229 mm
Power requirements100-240 VAC
Power consumption (standby)6 W
Power consumption (typical)34 W
Operating temperature (T-T)5 - 35 °C
Operating relative humidity (H-H)10 - 80 %
Weight and Dimensions IconWeight and Dimensions
Weight8400 g

Related product manuals