87
3.7 Detecting Multifeeds
3
SCANNING VARIOUS TYPES OF DOC-
4. Select the detection conditions from [Multifeed Detection] under [ADF
Option].
You can choose the following:
Furthermore, refer to
"7.5 Multifeed Detection Conditions" on page 168 for detailed information
about the document for multifeed detection.
5. Click the [OK] button.
The display returns to the [TWAIN Driver] dialog box. Then, perform the scanning operation
on the dialog box.
⇒ The scanner will stop scanning if multifeed detection is enabled in the middle of scanning
operation.
6. Push the [Send To] button on the operation panel.
⇒ Detected multifeeds will be ejected.
None Multifeed detection is not performed.
Check overlapping The scanner monitors for the overlapping of documents. The scanner detects a
multifeed by differences in ultrasonic propagation. When this method is
slected, two more options are available specified by other sections.
• Multifeed detection areas can be narrowed separately for left/middle/right
Ultrasonic sensors to avoid unintensional multifeed detection of sticked pho-
togragh or something on the document. To specify this, go to Step 4 in Sec-
tion “8.4 Multifeed Detection” on page 188.
• If photogragh or something is sticked on the document and its size and/or
position are same, you can easily let the scanner memorize its size and/or
position just scanning those document. To use this function, go to Section
“8.10 Intelligent multifeed setting” on page 200 or Section “3.12 Not detect-
ing Multifeed for fixed format” on page 99.
Check length The scanner monitors the length of documents. It detects a multifeed by differ-
ences in the document length when two or more document sheets are fed over-
lapping.
Check overlapping
and length
The scanner monitors both document overlapping and length to detect
multifeeds.
Hardware settings The scanner will detect multifeeds according the settings configured on the
Software Operator Panel. Refer to “8.4 Multifeed Detection” on page 188.
To Next Page
Loading...
