Fujitsu fi-5900C - Cleaning the Rollers (Using the Cleaning Sheet)

111
4.3 Cleaning the Rollers (using the cleaning sheet)
4
DAILY CARE
4.3 Cleaning the Rollers (using the
cleaning sheet)
Use the cleaning sheet to clean the upper and lower ADF transport path and the rollers.
1. Open the Pre-Imprinter Cover.
2. While pressing the [Scan] button , press the power button to
switch on the scanner.
⇒ The function number display will change as shown below.
3. Stop pressing the [Scan] button .
⇒ The scanner will be started up in the test mode.
4. Close the Pre-Imprinter Cover.
If all the cleaning is done, reset the Cleaning counter by referring “5.2 How to check and reset
the Consumable/Cleaning Counter” on page 125.
Pre-Imprinter Cover
Scan
Scan