180
8.1 Scanner Settings
［Device settings 2］
Selecting each item displays detailed settings (parameters) in the right part of the dialog box.
Item Explanation Selectable parameter Default
Multifeed
“Section 8.4”
Select the method to detect Multifeed.
(Check either of overlapping or document
length, or both of document length and over-
lapping)
None/Check Overlapping
[Ultrasonic]/Check Length/
Check Overlapping and
Length.
Selectable length (to be
detected as length difference):
10, 15 or 20mm
Check
overlapping
Multifeed detec-
tion when scan-
ning in manual
feeding mode
“Section 8.5”
Multifeed can be detected by this setting,
even if the manual feeding is set.
Disable/Follow driver settings Disable
To Next Page
Loading...
