Fujitsu fi-5900C

185
8.2 Power saving setting
8
SCANNER SETTINGS
8.2 Power saving setting
When not using this scanner for a certain time, it will enter automatically the power saving mode.
Configure the Power saving mode as follows:
1. Start up the Software Operation Panel.
Refer to “8.1 Scanner Settings” on page 177.
2. Select [Device Setting] from left side list in the window.
3. Use the slide control bar to set the waiting time before entering the power
saving mode.
Setting range 15 - 55 minutes. (Set in steps of 5 minutes)