Fujitsu fi-5900C

181
8.1 Scanner Settings
8
SCANNER SETTINGS
Page edge filler
(ADF)
“Section 8.6”
Fill the end sections of a specified-mm-wide
with white or black on the scanned image.
When the backing (background) color is
white, the end sections are filed with white;
and when the background color is black,
filled with black.
Top/left/right: 0-15mm
Bottom: -7 to 7mm (can be set
in increments of 1mm)
(A: Image area B: Filled area
A+B: Area to be output)
Top/Bottom/
Left/Right:
0mm
Dropout Color
“Section 8.7”
Drop out a preselected color for the scanned
image. (Binary black & white/grayscale
mode only)
Red/Green/Blue/None Green
Pre-Pick
“Section 8.8”
To give a higher priority to processing
speed, select [Yes], if not, select [No].
Yes/No Yes
Page edge filler
(Automatic paper
size detection)
“Section 8.9”
Fill the end sections of a specified-mm-wide
with white when the paper size is automati-
cally detected.
The end sections of a specified-mm-wide are
filled with white.
Top/Left/Right/Bottom: 0 to
7.5mm (can be set in incre-
ments of 0.5mm)
(A: Image area B: Filled
area
A+B: Area to be output)
Top/Bottom/
Left/Right:
0mm
Document check
area specifica-
tion for Multifeed
Detection
“Section 8.4”
• Selected range: This is checked to make
following checking area specification
effective.
• Enable/Disable: Specifies whether left/
middle/right each ultrasonic sensor is
enabled or disabled.
• Start: The start point of the check area in
length (mm) from top edge of the docu-
ment is specified.
• End: The end point of the check area in
length (mm) from top edge of the docu-
ment is specified.
• Selected range
• Enable/Disable
• 0 to 510 mm, with 2 mm
increment
• 0 to 510 mm, with 2 mm
increment
• Not
checked
• Invalid
• 0 mm
• 0 mm
Item Explanation Selectable parameter Default
A
B
A
B