119
4.5 Cleaning the Transport path and the sensors
4
DAILY CARE
3. Clean the supersonic sensors (three pieces), pick sensor (one piece), and
skew sensors (six pieces) installed in the lower transport path using a
cloth moistened with the cleaner F1.
4. Clean the supersonic sensors (three pieces) and the reflectors for the
pick sensor (one piece) and skew sensors (six pieces) installed in the
upper transport path using a cloth moistened with the cleaner F1.
It may take long before the cleaner vaporizes if a large quantity is used.
When cleaning the scanner parts, dampen a cloth with modest quantities
of the cleaner. In addition, wipe off the cleaner completely with a soft lint-
free cloth to leave no residue on the surface of the cleaned parts.
To Next Page
Loading...
