YES
YES
NO
NO
Did you adjust the offset
(starting position for scanning the
document)?
Have you used the "Page Edge Filler"
function?
Use the Software Operation
Panel to adjust the offset. (*1)
When you use this function, the
shadow on the leading edge
can be filled white.
Use the Software Operation
Panel to set the page edge
filling area. (*1)
Symptom 11
There is a shadow on the leading edge of the
generated image.
If the problem can not be resolved with this flowchart, refer to
"6.4 Before Contacting a Service Provider."
After checking the items given in section 6.4, contact an authorized
FUJITSU scanner service provider or your dealer.
To Next Page
Loading...
