Importan t notes
Power cable
Use the supplied power cable only.
Use the following guidelines if it is n ecessary to replace the original cable set.
• The female/male receptacles of the cord set must meet IEC60320/CEE-22 requirements.
• The cable has to be HAR-certified or VDE-certi fied . The ma rk HAR or
VDE will appear on the outer sheath.
• For devices w hich are mounted on a desk or ta ble, type SVT or SJT cable sets may be
used. For devices which sit on the floor, only S JT type cable sets may be used.
• The cable set must be selected according to the rated current for your d evice.
• If necessary, replace the original power cable with a regular grounded 3-core mains lead.
Transporting the device
Device,Transpor tationRetransportation
Transport all parts separately in the ir original packaging or in a packaging which
protects them from knocks and jolts, to the new site.
Do not unpack them until all transportation manoeuvres are completed.
If the device is brought from a cold environment into the room where it will be
used, condensation may occur. To avoid damaging the device, wait until it has
reached room temperature and is absolutely dry before initial startup.
Cleaning the device
Device,Transpor tationRetransportationS ystemunit, seeD evice
Turn off all po wer and e quipm ent switches and disconnect the power
plug from the mains outlet.
Do not clean any interior parts yourse lf, leave this job to a service technician.
Do not use any cleaning agents that contain abrasives or may corrode
plastic (alcohol, thinner or acetone).
Never clean the device with w a ter! Water entering into the device could
present a serious risk to users (e.g. electric shock).
Ensure that no liquid enters the system.
The surface of the monitor is sensitive to pressure and scratches. Clean
it only using a soft, slightly moistened cloth.
The surface can be cleaned with a dry cloth. If part icularly dirty, use a c loth that has been
moistened in mild domestic detergent and then carefully w rung out.
Use disinfectant wipes to clean the keyboard and the mouse.
Energy saving, disposal and recycling
DisposalEnergysavingRecyclingDrivers& UtilitiesDVDUser DocumentationDVD
You ca
n find information on these subjects in chapte r "
Activating power-saving
mode
", Page 31, on the "Drivers & Utilities", the recovery DVD or on our website
("
ht
tp://www.fujitsu.com/fts/about/ fts/environment-care/").
14 Fujitsu
To Next Page
Loading...
