Removing and installing componen ts
during servicing
Attaching the cover
2
1
► Place the cover in the correct mounting position (1).
If you remove more tha n one component at the same time, keep the screws for the
individual co m ponents sepa rately fro m each other and make sure that you use the
correct screws. If you insta ll the wrong screws, components may be damaged.
► Tighten the screw (2).
► Insert the battery (see Chapter "
Install ing a battery", Page 29).
Finishing component removal
After you have removed or changed t he system components as you requ ired, plea se
prepare your device for operation again as follows:
► Install the battery again (see "
Installing a batter y", Page 29).
► Turn the notebook the right way up again and place it on a flat surface.
► Reconnect the cables that you disconnected before.
58 Fujitsu Technology S olutions
To Next Page
Loading...
